Tank 1 Automatic Drink Dispenser for 4 Shot Glasses

Four servings with an eye-catching presentation

The Tank 1 automatic drink dispenser is configured for four shot glasses and makes pouring part of the table presentation. Its decorative tank rotates between the prepared positions, while the barrel serves as the spout. The mechanism fills the glasses in sequence, so each serving does not have to be measured by hand. The format suits a small group, and the recognizable tank silhouette complements a military or machinery-inspired table theme.

The drink is drawn directly from a bottle through a dispensing tube. Before starting, place the end of the tube in the liquid, connect the unit to power, and choose the serving amount on the control panel. The dispenser operates from mains power or a compatible power bank. Position a portable source so that its cable stays outside the path of the rotating body.

Preparation and operation

• Clear the area. Set the unit on a level, stable surface and leave enough open space around the tank for rotation.
• Arrange four shot glasses. Each glass must stand securely at its position, with its opening aligned with the barrel.
• Connect the bottle. Lower the tube far enough into the drink, avoiding pinches, twists, and sharp bends.
• Select a portion. Match the setting to the capacity of the glassware in use. For the initial setup, run a trial cycle with clean water.
• Start dispensing. Do not move the glasses or touch the rotating section until the cycle has finished.

Accurate glass placement

The four-glass version creates a compact serving zone around one mechanism. If different glassware is used, first check its height, stability, and position relative to the barrel. The rim must not obstruct the tank, and the stream should reach the centre. Keep the bottle, tube, and power cable outside the rotation path. Repeat a short water test after changing the drink or adjusting the portion setting.

Cleaning after use

Immediately after dispensing, run clean cool or slightly warm water through the tube. Rinse the liquid path when changing drinks as well, preventing residue and aromas from mixing inside it. Clean the tube without detergents. Wipe the body with a soft dry or lightly damp cloth; do not immerse the unit or allow water to enter the mechanism.

Let accessible parts dry before storage and arrange the tube loosely without kinks. Keep the dispenser in a dry place away from direct sunlight and heat sources. Before the next use, check that the tank rotates freely, all four shot glasses are positioned correctly, and the liquid path is unobstructed.